AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
3d printer slicer flow rate12/27/2023 If the slicer software has an extrude tool, you can type in 100 there.We can also do this by sending G-Code to the printer via the computer.In the menu that pops up, set the value to 100 using the control knob.To do this on the Marlin firmware, click on “Prepare > Extruder > Move 10mm”.Step 7: Now, extrude 100mm of filament through the printer. Step 6: Using a meter rule, measure a 110mm segment on the filament from where it enters the extruder. Step 5: Load the test filament into the printer. Step 4: Preheat the printer to the printing temperature of the test filament. Step 3: Set the printer to relative mode using the “M83” command.
0 Comments
Read More
Leave a Reply. |